Chapter 6 - Disassembly Guide
2. Remove the board by gently pulling to disconnect from LED connector.
Pull straight back to avoid bending the pins.
During reassembly, line up the LED connector when replacing the main
PCB in the front case assembly, press gently into position, and feed the
ribbon cable through the hole for the wheel.
3. Disconnect the backlight, keypad, speaker connector, and wheel ribbon
connector.
During reassembly, tuck the speaker cable out of the way.
There are now three separate items:
•
Front case assembly
•
Rear case assembly
•
Main PCB assembly
Rear case
assembly
Disassembly Procedures (A1)
Main PCB
assembly
Front case
assembly
69