Culligan 9" Owner's Manual page 26

01021076
22
Fill The Salt Storage Container
Fill the salt storage container with water until the level reaches about 1 inch above the salt support plate.
Pour salt into the container. Fill with salt to within a few inches of the top.
Brine Valve "A" Dimension
The brine valve contains a brine float which can serve as
a backup refill shutoff in the event of a failure, such as a
power outage when in the refill position. The float level
should be set based on the salt dosage setting. Refer to
Figure 16.
1. Remove nut retaining brine valve to brine cham-
ber.
2. Lift the brine valve from the brine chamber.
3. Find the correct "A" dimension in the HE
Softener Installation/Operation manual (PN
01021606).
4. Set the distance from the top of the filter screen
to the base of the float accordingly. The slight
difference in height when the float is pulled up
or down is negligible.
5. Re-install into brine chamber and replace nut.
Circuit Board Connections
The 24 Volt power supply and flow meter wire harness is already connected to the circuit board. If no
other circuit board connections are required proceed to the First Time Setup. Refer to the instructions below
and Figure 17 to Figure 20
WARNING! Disconnect all electrical power to the unit before connecting.
CAUTION! Grip all connections to the circuit board by the connecting
CAUTION! Do not touch any surfaces of the circuit board. Electrical static
NOTE Observe all state and local electrical codes.
for connecting the Aqua-Sensor probe wire harness to the circuit board.
terminals for assembly and disassembly. Failure to do so could
result in damage to the wire leads or connecting terminals.
discharges might cause damage to the board. Handle the
circuit board by holding only the edges of the circuit board.
Mishandling of the circuit board will void the warranty.
Figure 16. Brine valve "A" dimension.