D/N Level; D/N Delay - Siemens CCBS1337-LP Instruction Manual

7.2.2

D/N LEVEL

7.2.3

D/N DELAY

Siemens Building Technologies
Fire Safety & Security Products
D/N MODE AUTO
D/N LEVEL HIGH
D/N DELAY 15 sec
EXPOSURE <ALC>
SHUTTER 1/50
GAIN NORMAL
SYNC LL:000
BLC OFF
NEXT EXIT CANCEL DEFAULT
Fig. 2 D/N LEVEL
This function sets the filter switchover point to high, low or medium.
Configure a switchover point from COLOR mode to B/W mode. Move the cursor to
the position shown in Fig. 2. Use the LEFT/ RIGHT button to select HIGH, LOW or
MID. This setting is only relevant if the D/N mode is set to AUTO.
The brightness for switchover from COLOR to B/W mode is approx. 1 lux
LOW
MID The brightness for switchover from COLOR to B/W mode is approx. 2 lux.
HIGH The brightness for switchover from COLOR to B/W mode is approx. 4 lux.
D/N MODE AUTO
D/N LEVEL HIGH
D/N DELAY 15 sec
EXPOSURE <ALC>
SHUTTER 1/50
GAIN NORMAL
SYNC LL:000
BLC OFF
NEXT EXIT CANCEL DEFAULT
Fig. 3 D/N DELAY
This function sets the DELAY time for the D/ N function
Move the cursor to the position shown in Fig. 3.
Use the LEFT/ RIGHT button to select 0, 5, 10, 15 or 20 sec for delay of DN filter
moving timing. This setting is only relevant if the D/N mode is set to AUTO.
Info:
If using the camera together with infrared illumination , we recommend using video lenses with
special IR coating to prevent a physically based focus-shift between daylight and IR illumination.
We recommend using the D/N mode "MANUAL" when the camera is used with discrete IR
illumination in order to prevent the continual switching between color and B/W mode that might occur
with the D/N mode "AUTO"
Installing the Camera
15
03. 2005