Installing The Camera; Installation; Function Settings - Siemens CCBS1337-LP Instruction Manual

7

Installing the Camera

7.1

Installation

7.2

Function Settings

Siemens Building Technologies
Fire Safety & Security Products
1. Connect the BNC cable to the video output ⑥
2. Connect the power source to the power terminal
Caution:
If using a DC supply, make sure the polarity is correct. Incorrect connection may cause malfunction
and/or damage to the camera.
3. To reduce radiation sufficiently, please wind one turn around the core, see figure
below
Location
Power cable
Y/C cable
4. Adjust the back focus
The back focus is factory-adjusted before delivery for a CS mount lens. If re-
adjustment is necessary, please loosen screw ②, set the camera to AES mode
(see section 7.2.14.2: BACK FOCUS), then rotate the back focus wheel ① until a
sharp image appears. Tighten screw ②.
Select ENTER on the OSD; the menu will appear on the display and will disappear
after 30 seconds if no action occurs. The shaded setting area means an item is
selected; it keeps blinking.
Core illustration
Installing the Camera
for what camera
LP
LP / MP
EIM-0050751G
13
03. 2005