Bracket Installation; Removal Of Shipping Magnet - Safety Vision OBSERVER 2100 User Manual

Bracket Installation

A magnet is installed on the backside of the DVR
Monitor to prevent discharge of the back-up
battery during shipping.
1.
Secure the bracket to a stable surface
with screws, rivets, or other appropriate
mounting devices.
2.
Slide the Observer 2100 unit into the
bracket and secure it loosely with the four
supplied screws.
3.
Adjust the viewing angle and ensure
cables have enough slack.
4.
Firmly tighten all four screws.

Removal of Shipping Magnet

A magnet is installed on the backside of the DVR
Monitor to prevent discharge of the back-up
battery during shipping.
5.
Using the included L-wrech, unscrew the
bolt on the back of the monitor.
6.
Remove the magnet using the end of a
paperclip or similar device.
7.
Use the L-wrech to replace the bolt
securely to ensure a tight seal.
The DVR Monitor's back-up battery is now active.
OBSERVER 2100 USER GUIDE
NOTE: Do not install the Observer 2100
DVR Monitor in an area that could
interfere with the safe operation of the
vehicle.
9
9