Anynet+ (Hdmi-Cec) Isn't Working - Samsung LED 6400 Series E-Manual

Anynet+ (HDMI-CEC) isn't working.

The Problem
Anynet+ does not
work.
I want to start
Anynet+.
I want to exit Anynet+.
The message
"Connecting to
Anynet+ device..."
or "Disconnecting
from Anynet+ device"
appears on the screen.
Confirm that the device is an Anynet+ device. The Anynet+ system supports
Anynet+ devices only.
Check if the power cord of the Anynet+ device is properly connected.
Check the cable connections of the Anynet+ device.
Go to System and see if
Check whether the TV remote control is in TV mode.
Check whether the remote control is Anynet+ compatible.
Anynet+ may not function when certain functions are operational. (Channel Search,
Smart Hub, set up, etc.)
If you have disconnected and then reconnected the HDMI cable, scan for devices
again or turn your TV off and on.
Check if the Anynet+ device is properly connected to the TV and then navigate to
the System menu to see if
Once verified, select TOOLS
from the list and then a device.
Select View TV from the Anynet+ menu.
Select a non-Anynet+ device from the
You cannot use the remote control when you are configuring Anynet+ or switching
to a viewing mode. Use the remote control after the TV has completed the Anynet+
configuration or has switched to a viewing mode.
Try this!
Anynet+ (HDMI-CEC)
Anynet+ (HDMI-CEC)
button. A list appears. Select
Source list.
has been set to On.
is set to On.
Anynet+ (HDMI-CEC)