Nokia DC-1 Quick Manual page 3

Charge power pack
Before you can use the power pack to
charge a battery in a compatible
Nokia device, you must charge the
internal battery of the power pack.
The power pack has an internal,
nonremovable, rechargeable battery.
Do not attempt to remove the battery
from the device, as you may damage
the device.
1. Plug the charger cable into the
charger connector indicated with
"DC IN".
2. Connect the charger to a power
source. The green indicator lights
roll while charging. The more lights
are shown, the more charge is left
in the power pack. Charging the
power pack fully may take up to 10
hours if the power pack is not
connected to a Nokia device.
3. When the battery is fully charged,
all four green indicator lights are
shown. Disconnect the charger
from the power source, and unplug
the charger cable from the power
pack.
While the power pack is connected to
a charger, you can use the power pack
to charge one or two Nokia devices.
If the power pack cannot be charged
(for example, because the operating
temperature is too low or high), the
red indicator light is shown.
To check how much charge is left in
the power pack when it is not
connected to a device, press and hold
the power key for about 2 seconds. If
the amber indicator light is shown, the
power pack is discharged and must be
charged again for use.
ENGLISH