Final Transmission Oil - Yamaha YW125Z Owner's Manual

Final transmission oil<IXE>

Final transmission oil

The final transmission case must be
checked for oil leakage before each ride.
If any leakage is found, have a Yamaha
dealer check and repair the scooter. In
addition, the final transmission oil must
be changed as follows at the intervals
specified in the periodic maintenance
and lubrication chart.
1. Start the engine, warm up the final
transmission oil by riding the
scooter for several minutes, and
then stop the engine.
2. Place the scooter on the
centerstand.
3. Place an oil pan under the final
transmission case to collect the
used oil.
PERIODIC MAINTENANCE AND ADJUSTMENT
EAU20064
1. Final transmission oil filler cap
4. Remove the final transmission oil
filler cap and final transmission
drain bolt to drain the oil from the
final transmission case.
5. Install the final transmission oil
drain bolt, and then tighten it to the
specified torque.
1
1. Final transmission oil drain bolt
6. Refill with the specified amount of
6-12 6-49
1
Tightening torque:
Final transmission oil drain bolt:
23 Nm (2.3 m • kgf, 16.6 ft • lbf)
the recommended final transmis-
sion oil, and then install and tighten
the oil filler cap. WARNING! Make
sure that no foreign material en-
ters the final transmission case.
Make sure that no oil gets on the
tire or wheel.
[EWA11311]
Recommended final transmission oil:
See page 8-1.
Oil quantity:
0.13 L (0.14 US qt, 0.11 Imp.qt)
EAU1722A
1
2
3
4
5
6
7
8
9