Korg 61key Owner's Manual page 5

3.
As shown in the illustration, fold in the tab portion of
each locking support "B" that had been used to attach the
module to the keyboard assembly in step 1.
4.
Raise each of the locking supports "B" to the appropriate
position as shown in the illustration below.
5.
Slowly lower the module onto the locking supports "B,"
ensuring that the screw hole of each locking support "B"
is aligned with the screw holes on the rear of the module.
At this time, the protrusion of each locking support "B"
will fit into a notch on the bottom of the module, helping
to hold the module in place as you perform the next step.
Be careful not to pinch your hand between locking sup-
ports "B" and the module.
If you move the keyboard assembly or apply excessive
force to the module before you've fastened the module
in place with the screws, the module may fall down,
causing injury.
Lowering the module
1.
Remove the two screws that fasten the module's rear panel
to the keyboard assembly. Then grasp the handle affixed
to the module's rear panel, and lift the module up.
2.
While supporting the module with one hand, fold in each
of the locking supports "B", and fold out the tab portion
that had been inside.
Be careful not to pinch your hand between locking sup-
ports "B" and the module.
3.
Gently lower the module, and fasten the tab portion of
each locking support "B" to the module's rear panel us-
ing the screws you removed in step 1.
Be careful not to pinch your hand between the module
and keyboard assembly.
M U SI
C W
O R KS
TA TI
O N/
SA M
PL ER
5