When the phone rings, your HP all-in-one will answer automatically after the number of
rings you set in the
tones to the sending fax machine and receive the fax.
Case B: Set up your HP all-in-one with DSL
If you have a DSL service through your telephone company, use the instructions in this
section to connect a DSL filter between the telephone wall jack and your HP all-in-one.
The DSL filter removes the digital signal that can interfere with your HP all-in-one from
communicating properly with the phone line. (DSL might be called ADSL in your
not be able to send and receive faxes with your HP all-in-one.
Back view of the HP all-in-one
1 Telephone wall jack
2 DSL filter and cord supplied by your DSL provider
3 Phone cord supplied in the box with your HP all-in-one connected to the "1-LINE" port
To set up your HP all-in-one with DSL
Obtain a DSL filter from your DSL provider.
Using the phone cord supplied in the box with your HP all-in-one, connect one end
to the open port on the DSL filter, then connect the other end to the port labeled
"1-LINE" on the back of your HP all-in-one.
Connect the DSL filter cord to the telephone wall jack.
Run a fax test. For information, see
Rings to Answer
If you have a DSL line and you do not connect the DSL filter, you will
If you do not use the supplied cord to connect from the telephone
wall jack to your HP all-in-one, you might not be able to fax successfully.
This special phone cord is different from the phone cords you might already
have in your home or office.
setting. Then it will begin emitting fax reception
Test your fax
HP Photosmart 2600/2700 series all-in-one