Transport Position, Handlebar; Fitting Blades And Trimmer Heads; Fitting A Blade Guard, Grass Blade And Grass Cutter; Fitting The Blade Guard And Saw Blade - Husqvarna 232R Operator's Manual

Hide thumbs Also See for 232R:
Table of Contents

Advertisement

Transport position, handlebar

The handlebar can easily be turned to fit along the shaft
for easier transportation and storage.
Loosen the knob. Turn the handlebar clockwise so that the
throttle handle rests against the engine.
Now twist the handlebar around the shaft. Tighten the
knob.
Fit the transport guard to the cutting attachment.

Fitting blades and trimmer heads

When fitting the cutting attachment it is extremely important
that the raised section on the drive disc/support flange
engages correctly in the centre hole of the cutting attachment.
If the cutting attachment is fitted incorrectly it can result in
serious and/or fatal personal injury.
WARNING! Never use a cutting attachment
!
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
IMPORTANT! If a saw blade or grass blade are to be used
the machine must be equipped with the correct handlebar,
blade guard and harness.
Fitting a blade guard, grass blade
and grass cutter
G
F
E
D
A
B
C
L
M
The blade guard (A) is fitted using 4 screws (L) and the
support plate (M) as shown.
CAUTION! Always use the recommended guard for the
cutting attachment you are using. See chapter on
Technical data.
ASSEMBLY
Fit the drive disc (B) on the output shaft.
Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
Insert the locking pin (C) in the hole to lock the shaft.
Place the blade (D), support cup (E) and support flange
(F) on the output shaft.
Fit the nut (G). The nut must be tightened to a torque of
35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool
kit. Hold the shaft of the spanner as close to the blade
guard as possible. To tighten the nut, turn the spanner in
the opposite direction to the direction of rotation (Caution!
left-hand thread).
Fitting the blade guard and saw
blade
Secure the adapter (H) using the four screws (I).
The blade guard (A) is fitted using 4 screws (L) as shown.
CAUTION! Always use the recommended guard for the
cutting attachment you are using. See chapter on
Technical data.
A
Fit the drive disc (B) on the output shaft.
B
Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
I
H
L
G
F
D
C
– 17
English

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

235r

Table of Contents