Air Filter; Gear - Husqvarna 325HE3 X-series Operator's Manual

spark plug should be replaced after about a month in
operation or earlier if necessary.
CAUTION! Always use the recommended spark plug
type! Use of the wrong spark plug can damage the piston/
cylinder. Check that the spark plug is fitted with a
suppressor.
Air filter
The air filter must be regularly cleaned to remove dust
and dirt in order to avoid:
• Carburettor malfunctions
• Starting problems
• Loss of engine power
• Unnecessary wear to engine parts.
• Excessive fuel consumption.
Clean the filter every 25 hours, or more regularly if
conditions are exceptionally dusty.
Cleaning the air filter
Remove the air filter cover and take out the filter. Wash it
clean in warm, soapy water. Ensure that the filter is dry
before refitting it.
An air filter that has been in use for a long time cannot be
cleaned completely. The filter must therefore be replaced
with a new one at regular intervals. A damaged air filter
must always be replaced.
If the machine is used in dusty conditions the air filter
should be soaked in oil. See instructions under the
heading Oiling the air filter.
20 – English
MAINTENANCE
Oiling the air filter
Always use HUSQVARNA filter oil, art. no. 531 00 92-48.
The filter oil contains a solvent to make it spread evenly
through the filter. You should therefore avoid skin contact.
Put the filter in a plastic bag and pour the filter oil over it.
Knead the plastic bag to distribute the oil. Squeeze the
excess oil out of the filter inside the plastic bag and pour
off the excess before fitting the filter to the machine. Never
use common engine oil. This would drain through the filter
quite quickly and collect in the bottom.

Gear

There is a grease nipple and a plug for filling lubricant on
the gear housing. Use a grease gun to fill with grease.
New machines are first filled with grease after
approximately 20 hours of operation, and subsequently
approximately every 60 hours of operation. Use
Husqvarna's special grease, no. 503 98 96-01.
CAUTION! The gear housing must not be filled
completely with grease. The grease expands as the
machine heats up during operation. If the gear housing
was completely filled with grease it could damage the
seals and lead to leakage of grease.
The grease in the bevel gear does not normally need to
be changed except if repairs are carried out.