Faxing From A Dsl Line - HP 1240 Series User Manual

chapter 7

faxing from a DSL line

If you have a digital subscriber line (DSL) service through your phone company,
use the instructions in this section to connect a DSL filter between the telephone
wall jack and your HP Fax. This filter removes the digital signal that would block
your HP Fax from communicating properly with the telephone line.
Caution!
filter, you will not be able to send and receive faxes with your
HP Fax.
Telephone
wall jack
Caution!
DSL filter to your HP Fax, you may not be able to fax successfully.
If you live in one of the countries listed in the table on page 77,
you received a special 2-wire cord. This special 2-wire cord is
different from the more common 4-wire phone cords you might
already have in your office. For more information about how to
tell the difference between the cords, see
sending faxes and when receiving faxes.
1 Obtain a DSL filter from your DSL provider.
2 Using the phone cord supplied in the box with your HP Fax, connect one
end to the open port on the DSL filter, then connect the other end to the
port labeled "1-LINE" on the back of your HP Fax.
3 Connect the DSL filter cord to the telephone wall jack.
4 Proceed to
page 77 to determine what else you need to do to finish setting up your
HP Fax.
76
If you have a DSL line and you do not connect the DSL
Use the phone cord supplied in
the box with your HP Fax
DSL filter
Back view of the
supplied by your
If you do not use the supplied cord to connect from the
how to tell if the following instructions apply to you
I have difficulties when
on page 105.
on
hp fax 1240 series