Specifications; Notes On Putting Into Service - Cisco BWX360 WiMAX User Manual

Enter the IP address of your Cisco BWX360 WiMAX Outdoor Modem as the Web-
site address: 192.168.2.1
Click on the Allow button.
Click on Close and on OK to apply the settings.

Specifications

Model
Dimensions
Outdoor Modem:
Indoor unit:
Operating temperature
Outdoor Modem:
Indoor unit:
Network interface
Frequency
Output power
Power consumption
Bandwidth
Type of transmission
Modulation technique
Subcarrier modulation
Antenna type
Antenna gain
Mains adapter

Notes on putting into service

This device will only operate on Sprint or Clearwire's U.S. WiMAX network. It is not
intended for use on any other network.
Please observe the legal provisions and local restrictions when putting the
device into service. Please ask your service provider for further information.
THE SPECIFICATIONS AND INFORMATION REGARDING THE PRODUCTS IN
THIS MANUAL ARE SUBJECT TO CHANGE WITHOUT NOTICE. ALL STATE-
MENTS, INFORMATION, AND RECOMMENDATIONS IN THIS MANUAL ARE
BELIEVED TO BE ACCURATE BUT ARE PRESENTED WITHOUT WARRANTY OF
ANY KIND, EXPRESSED OR IMPLIED. USERS MUST TAKE FULL RESPONSIBIL-
ITY FOR THEIR APPLICATION OF ANY PRODUCTS.
NOTWITHSTANDING ANY OTHER WARRANTY HEREIN, ALL DOCUMENT FILES
AND SOFTWARE OF THESE SUPPLIERS ARE PROVIDED "AS IS" WITH ALL
Cisco BWX360 WiMAX Outdoor Modem
approx. 228.5 x 208 x 101 mm
approx. 140 x 65 x 36 mm
–40 °C to +60 °C
0 °C to +40 °C
1 Ethernet 10/100BaseT (RJ45, LAN)
2.3–2.4 / 2.5–2.7 / 3.4–3.6 GHz
up to 26 dBm at QAM-16
3-6 W on DC input depending on operational state
optional: 3.5 / 5.0 / 7.0 / 8,75 or 10.0 MHz
TDD
SOFDMA 512/1024
QPSK, 16/64 QAM in up- and downlink
2 internal antennas (2xRX, 1xTX) for MIMO Matrix
A & B; Type DN1 (EN 302 326-3 V1.2.2)
10 / 11 dBi (2.6 / 3.5 GHz)
Input: 100–240 V AC, Power over Ethernet (PoE)
Specifications
47