Adding Channels To The Tv's Memory - Toshiba 34HFX84 Service Manual

ADDING CHANNELS TO THE TV'S MEMORY

When you press Channel
Follow the steps below and on the this page to program all active channels into the TV's memory.
Programming channels automatically
Your TV can automatically detect all active channels in your
area and store them in its memory. After the channels are
stored automatically, you can manually add or erase individual
channels .
To program channels automatically:
Press MENU, and then press
1
menu appears.
2 2
Press or until the TV/CABLE is highlighted, and then
press ENTER to display the pull-down menu.
3
Press or to highlight either TV or CABLE, depending
on which you use. If you use an antenna, highlight TV; if
you use cable, highlight CABLE.
4
Press ENTER.
5
Press to select CH PROGRAM.
6
Press ENTER to start channel programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active
channels in the channel memory.
While the TV is cycling through the channels, the mes-
sage "Programming Now"-Please Wait" appears.
7
When channel programming is complete,the message
"Completed" appears.
8
Press Channel or to view the programmed channels.
or , your TV will stop only on the channels stored in the TV's channel memory.
Adding and erasing channels manually
After you have programmed the channels automatically, you
can manually add or erase specific channels.
To add or erase channels:
or until the SET UP
1
2
3
4
5
- 14 -
Select the channel you want to add or erase. If you are
adding a channel, you must select the channel using the
Channel Number buttons.
Press MENU, and then press
menu appears.
Press or to highlight ADD/ERASE, and then press
ENTER to display the pull-down menu.
Press or to select ADD or ERASE, depending on the
function you want to perform.
Repeat steps 1-4 for other channels you want to add or
erase.
or until the SET UP