Proper Usage And Handling - Canon CP-330 User Manual

16
Proper Usage and Handling
.. Usage Location
Do not use near strong magnets or near devices that produce strong electromagnetic
fields. Electromagnetic radiation from devices such as TVs and game machines, and strong
magnetic fields from devices such as speakers and large motors, may cause distortion in
printed images.
Use in a well-ventilated, level area.
Leave about 15 cm (6 in.) of clearance at the front and back of the devices and 10 cm
(4 in.) of clearance on both sides. Be sure to leave clearance around the paper-handling
slot (at the rear) so that paper has sufficient room to jut out from the slot during printing.
Peel off the protective seal on the top of the printer.
The air vents are covered by a protective seal. If you use the printer before removing the
protective seal, the printer may stop operating because of heat built-up inside the printer.
II
Handling Precautions
Please avoid turning the printer's power on and off needlessly as the printer
initialization consumes ink: There may not be enough ink left for the allotted sheets in the
set.
When the printer is not in use, please remove the battery pack (CP-330 only).
Unplug the printer when you are not using it. But please note that you should plug in and
run the printer at least once every six months to ensure that it remains functional.
Before transporting the printer, remove the paper and ink cassettes and close the
paper cassette cover and the ink cassette cover. If dirt or foreign objects enter the printer,
print quality may deteriorate.
-~
..
_._._._---~_.-------------------
Pack the printer into an appropriate case for transport. If a case is not available, wrap it
with cloth or other protective material to protect against scratches.
- - - - - - - - - - - - -
Never use volatile compounds or insecticides on the printer, and do not allow rubber
or vinyl material to remain in prolonged contact with the printer. These materials may
cause deformation of the printer's casing.
o
Overheating
If the printer overheats, it will temporarily stop operating. This does not mean that the
printer has malfunctioned. The printer will resume normal printing as soon as it cools
down.
Temporary stoppages are most likely to occur in the following cases:
• When printing continuously.
• If the room is unusually warm.
• If the air vents on the top of the printer are blocked or if ventilation is inadequate.