Appendix; Image Backup And Recovery Procedures; Creating A Backup Of Bootable Disk And Recovery Image - Fujitsu STYLISTIC Q704 Operating Manual

Hide thumbs Also See for STYLISTIC Q704:
Table of Contents

Advertisement

Appendix

Image Backup and Recovery Procedures

Thank you for purchasing a Fujitsu computer. Fujitsu is committed to bringing you
the best computing experience with your new system.
It is very important that you create DVD copies of your Recovery Image and Bootable Disk
before beginning to use your system. To do so, follow the instructions in the "Creating a
Backup of Bootable Disk and Recovery Image" section of this document.
It is also important that you create a copy of the software that is essential for your system to access the
internet (hereafter called "essential access software") to external writable media or an external drive.
To do so, follow the instructions in the "Creating a Backup of the System-Specific Software Drivers".

Creating a Backup of Bootable Disk and Recovery Image

When you purchased your new system, a copy of the recovery image was loaded into a
hidden partition on your hard disk drive. Having a copy of the recovery image available to
you means that in the event of system failure, you will be able to restore it and re-install
the essential access software using Fujitsu Software Auto Installer.
To make a copy of the recovery image to DVD disks, you will need three or four blank
disks to create the copy. After creating the copy, be sure to label the disks and keep
them in a safe place to ensure they do not get damaged.
Note: If your system does not have an internal writable DVD drive, connect your
system to an external drive* before beginning the following steps.
1. Launch System Restore and Recovery from the desktop icon. It will allow you to create
the Bootable Disk and the Recovery Image Disk Set.
2. On "Step 1: Select the Bootable Disk from the list":
a. Select a media type.
b. Notice the number of disks that are needed for the set.
c. Click Next to proceed.
3. On "Step 2: Confirm your Recovery Disk", click Next.
4. On "Step 3:" follow the on-screen instructions to make the disk or disk set, then click
Start. It takes approximately 20 minutes to make one disk.
5. On "Step 4", when the disk creation is completed, a message appears.
Click Finish to exit the program.
6. Repeat Step 1: Select Recovery Disk from the list and repeat the above
steps 2(a), 2(b), 2(c), 3, 4 and 5.
* DEPENDING UPON YOUR OPTICAL DRIVE AND MEDIA FORMAT USED, SOME MEDIA
TYPES MAY BE INCOMPATIBLE FOR CREATING IMAGE BACKUPS.
Fujitsu
Appendix
93

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents