Download Print this page
American Standard ARCH M968586 Installation Instructions
American Standard ARCH M968586 Installation Instructions

American Standard ARCH M968586 Installation Instructions

Single control kitchen pull-out faucet

Advertisement

Quick Links

ARCH
SINGLE CONTROL
KITCHEN PULL-OUT FAUCET
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--
please read these instructions carefully before you begin.
RECOMMENDED
TOOLS
1
INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON
Installation with ESCUTCHEON: Figure A.
mounting surface is uneven. Insert SEAL (1) into groove at base of faucet. Insert supply HOSES (2) and SHANK (3)
through ESCUTCHEON (4) and mounting surface.
Assemble RUBBER WASHER (5), BRASS WASHER (6) and threaded LOCKNUT (7) onto SHANK (3) from underside
of sink or mounting surface. Hand tighten LOCKNUT (7) and check that rotation of HANDLE (8) from HOT to COLD
is centered.
Use a screwdriver to tighten SCREWS (9) on LOCKNUT (7). Work your way around LOCKNUT (7), tightening the screws
slightly each time until all are snug to ensure even pressure.
Installation for single hole mounting: Figure B.
SEAL (1) into groove at base of faucet. Insert supply HOSES (2) and SHANK (3) through ESCUTCHEON (11) and mounting surface.
Assemble RUBBER WASHER (5), BRASS WASHER (6) and threaded LOCKNUT (7) onto SHANK (3) from underside of
sink or mounting surface. Hand tighten LOCKNUT (7) and check that rotation of HANDLE (8) from HOT to COLD
is centered.
Use a screwdriver to tighten SCREWS (9) on LOCKNUT (7). Work your way around LOCKNUT (7), tightening the screws
slightly each time until all are snug to ensure even pressure.
8
Figure A
1
2
4
S I N K O R
M O U N T I N G
S U R FA C E
5
9
Adjustable Wrench
Apply a light bead of plumbers putty to underside of ESCUTCHEON (1) if
7
G R O O V E I N FA U C E T
3
6
7
Installation
Instructions
4101.100
Regular Screwdriver
CAUTION
Insert SEAL (10) into groove at base of ESCUTCHEON (11). Insert
S I N K O R
M O U N T I N G
S U R FA C E
Certified to comply with ANSI A112.18.1M
Phillips Screwdriver
Turn off water at
main supply.
8
7
Figure B
1
G R O O V E I N FA U C E T
11
10
G R O O V E I N E S C U T C H E O N
3
2
5
6
7
9
M 9 6 8 5 8 6 R ev. 1. 1
Channel Locks

Advertisement

loading

Summary of Contents for American Standard ARCH M968586

  • Page 1 ARCH SINGLE CONTROL KITCHEN PULL-OUT FAUCET Thank you for selecting American-Standard... the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly-- please read these instructions carefully before you begin. RECOMMENDED TOOLS Adjustable Wrench INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON Installation with ESCUTCHEON: Figure A.
  • Page 2 MAKE WATER SUPPLY CONNECTIONS Turn off hot and cold water supplies before beginning. Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply (Marked with a Red Stripe) to Hot and right supply (Marked with Blue Stripe) to Cold wall supply.
  • Page 3 TEST INSTALLED FAUCET Move HANDLE (1) down into "off" position. Turn on water supplies. Check connections for leaks. Remove AERATOR (2). With HANDLE (1) down in "off" position, pull HAND SPRAY (3) from FAUCET (4). SPRAY (HOSE (3) should pull approximately 2 feet and direct open SPRAY END (3) into sink.

This manual is also suitable for:

Arch 4101.100