Answering Calls From The Entrance Telephone And Opening The Door36 - Siemens HiPath 2000 Operating Instructions Manual

Enhanced phone functions
Step by Step
Open door?
*61=Open door?
36
Answering calls from the entrance telephone
and opening the door
If an entrance telephone has been programmed, you
can use your telephone to speak to someone at the en-
trance telephone and to activate a door opener.
If you have the proper authorization (contact your ser-
vice personnel), you can activate the door opener, en-
abling visitors to open the door themselves by entering
a 5-digit code (using a DTMF transmitter or installed
keypad).
Speaking to visitors via the entrance telephone
Prerequisite: Your telephone rings.
^
Lift the handset within thirty seconds. You are connect-
ed to the entrance telephone immediately.
or
^
Lift the handset after more than thirty seconds.
j
Dial the entrance telephone number.
Opening the door from your telephone during a call
from the entrance telephone
Confirm.
Opening the door from your telephone without
calling the entrance telephone
N
Press the key shown.
Select and confirm the option shown.
j
Dial the entrance telephone number.
Special features must be taken into consider-
ation if your telephone operates with
HiPath 5000 (system networking via PC
network)
Opening the door with a code (at the door)
j
After ringing the bell, enter the five-digit code (using the
keypad or a DTMF transmitter). Depending on how the
door opener has been programmed, a doorbell call sig-
nal may or may not be forwarded.
page 89!