Table of Contents
Advertisement
Specifications
Batteries
Technology: Nickel-metal-hydride (NiMH); Size: AAA (Micro, HR03); Voltage: 1.2 V;
Capacity: 450 - 1000 mAh
General specifications
DECT standard
GAP standard
Range
Base station power supply
Environmental conditions
in operation
Base station power consumption
In standby mode
– Handset in base station
– Handset outside base station
During a call
Questions and answers
If you have any queries about the use of your telephone, visit our website at
www.gigaset.com/service
for 24-hour support. The table below contains a list of common problems and possible
solutions.
Problem
Cause
Nothing
The handset is not switched
appears in
on.
the display.
The batteries are flat.
No wireless
The handset is outside the
connection
range of the base station.
to the base
The handset is not regis-
station,
tered.
Base flashes in
The base station is not
the display.
turned on.
is supported
is supported
up to 300 m outdoors, up to 50 m indoors
230 V ~/50 Hz
+5 °C to +45 °C, 20% to 75% relative humidity
A130/A230
AL130A/AL230A
ca. 1.0 W
ca. 1.2 W
ca. 0.8 W
ca. 1.0 W
ca. 1.0 W
ca. 1.2 W
Solution
a
Press the end call key
5 seconds or place the handset in
the base station.
Charge or replace the batteries.
Move the handset closer to the base
station.
¢
Register the handset
page 10.
Check the mains connector on the
¢
base station
page 5.
13
Problem
You cannot
hear a ringer/
dialling tone
from the fixed
line network.
Error tone
sounds after
system PIN
prompt.
PIN forgotten.
Contact with liquid
If the device comes into contact with liquid:
1
Disconnect the power supply.
2
Remove the batteries and leave the battery compartment open.
3
Allow the liquid to drain from the device.
4
Pat all parts dry.
5
Place the device in a dry, warm place for at least 72 hours (not in a microwave,
oven etc.) with the battery compartment open and the keypad facing down (if ap-
plicable).
6
Do not switch on the device again until it is completely dry.
When it has fully dried out, you will normaly be able to use it again.
Service (Customer Care)
for approx.
Step by step towards your solution with Gigaset Customer Care
www.gigaset.com/service
Cause
Solution
The phone cord supplied
Please always use the phone cord
has not been used or has
supplied or ensure that the
been replaced by a new cord
pin connections are correct when
with the wrong jack connec-
purchasing from a retailer: 3-4
tions.
assignment of telephone leads/
EURO CTR37.
The system PIN you have
Reset the system PIN to the default
entered is incorrect.
0000
All handsets are de-registered. All
settings are reset. All lists are
deleted.
!
Visit our Customer Care pages:
www.gigaset.com/service
Here you will find:
◆
Frequently asked questions
◆
Free software and user manual downloads
◆
Compatibility checks
¢
page 12.
Hide quick links:
Advertisement
Table of Contents
