Connecting The Signal Source; Connecting The Fm Radio Antenna - HP Media Center PC User Manual

18
HP Media Center PC User's Guide

Connecting the Signal Source

This section describes connecting the signal source
for TV.
Connect the signal source for the TV by using the
TV (in) coaxial connector or the S-VID IN (S-video)
connector:
Plug the connector of a coaxial cable from
■
your TV antenna or from your TV cable (wall
or set-top box) into the TV/RF-IN (D) connector
on the back of the PC, and then turn the
connector to tighten it.
Or
Plug a cable into the S-VID IN (C) connector
■
on the back of the PC; use an S-video cable
(not provided) or use the S-video to composite
video adapter cable and the composite video
cable. Plug the other end of the cable into
your set-top box, VCR, or other device that is
providing the signal source for the TV.
A

Connecting the FM Radio Antenna

(Select Models Only)
1
Plug the FM radio antenna cable into the
FM-IN (E) port on the back of the PC. The FM
connector is found on the TV tuner card.
2
You may want to extend the ends of the cable
to improve your FM radio signal reception.
You can also plug audio cables (not provided)
from your set-top box or VCR into the Audio in
right (red) (A) connector and the Audio in left
(white) (B) connector on the back of the PC.
B C D E