10 Power Cord Set Requirements; Requirements For All Countries Or Regions - HP PAVILION DX6500 Maintenance And Service Manual

10 Power cord set requirements

The wide range input feature of the computer permits it to operate from any line voltage from 100 to 120
volts AC or from 220 to 240 volts AC.
The 3-conductor power cord set included with the computer meets the requirements for use in the country
or region where the equipment is purchased.
Power cord sets for use in other countries or regions must meet the requirements of the country or region
where the computer is used.

Requirements for all countries or regions

The requirements listed below are applicable to all countries or regions:
The length of the power cord set must be at least 1.5 m (5.0 ft) and no more than 2.0 m (6.5 ft).
●
All power cord sets must be approved by an acceptable accredited agency responsible for evaluation
●
in the country or region where the power cord set will be used.
The power cord sets must have a minimum current capacity of 10 amps and a nominal voltage rating
●
of 125 or 250 V AC, as required by each country or region's power system.
The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320 Standard
●
Sheet C13 connector for mating with the appliance inlet on the back of the computer.
Requirements for all countries or regions 121