Simulation List - Sharp AR-M355N Quick Reference Manual

Simulation List (Main/Sub)
Code
Main Sub
1 1 Used to check the operations of the scanner (read) unit and its control circuit.
2 Used to check the operation of sensor and detector in the scanning (read) section and the related circuit.
2 1 Used to check the operations of the automatic document feeder unit and the control circuit.
2 Used to check the operations of the sensors and detectors in the automatic document feeder unit and the related circuits.
3 Used to check the operations of the loads in the automatic document feeder unit and the control circuits.
3 2 Used to check the operation of sensor and detector in the finisher and the related circuit.
3 Used to check the operation of the load in the finisher and the control circuit.
6 Used to adjust the stacking capacity of the finisher. (Used to adjust the alignment plate [jogger] stop position in the finisher
paper width direction. The adjustment is made by changing the alignment plate home position in the paper width direction by
software.)
10 Console finisher (AR-FN7) adjustment.
20 Used to check the mail bin stacker sensor.
21 Used to check the operations of the mail bin stacker loads.
4 2 Used to check the operations of the sensors and detectors in the paper feed section (desk paper feed/large capacity tray) and
the related circuit.
3 Used to check the operations of the loads in the paper feed section (desk paper feed/large capacity tray) and the related circuit.
5 1 Used to check the operation of the display, LCD in the operation panel and control circuit.
2 Used to check the operation of the heater lamp and the control circuit.
6 1 Used to check the operation of the paper transport system loads and the control circuit.
2 Used to check the operations of each fan motor and its control circuit.
7 1 Used to set the operating conditions of aging.
6 Used to set the intermittent aging cycle.
8 Used to set the warm-up time display YES/NO.
Quick Reference Guide: AR-M355N/M455N
Function (Purpose)
Simulation List (Pg. 1 of 10)
6