Download Print this page

Installation Procedures - Haier HPU-48HK03 Operation & Installation Manual

Cabynet type air conditioner
Hide thumbs

Advertisement

Installation procedures

Note:
Electric wiring must be done by qualified person.
Use copper wire only, the parameter of connecting cable is H07RN-F 4G 0.75mm
The power cable should be over 5G2.5mm
are self-provided.
The power supply connects from the outdoor unit.
Wiring of indoor unit
Insert the cable from outside the wall hole where piping already exist.
Pull it out from front.
Loosen terminal screws and insert cable end fully into terminal block, then tighten it.
Pull the cable gently to make sure it is tight.
Replace cover after wiring.
Wiring of outdoor unit
Insert the cable from inside the wall hole
where piping already exists.
Pull it out from front.
Loose terminal screw and insert cable end fully
into terminal block, then tighten it.
Pull the cable gently to make sure it is tight.
Replace cover after wiring.
HPU-42CH03 HPU-48CJ03 HPU-48HJ03 HPU-42HH03 HPU-42HI03 HPU-48HK03
Y/G
Note:
When connecting indoor and outdoor wire, check the number on indoor and outdoor
terminal blocks.Incorrect wiring may damage air conditioner's controller or cause
operation failure.
INDOOR UNIT TERMINAL BLOCK
1
2
3
R S T
N 1 2 3
POWER SUPPLY
2
, the power cable and connecting cable
Y/G
OUTDOOR UNIT
TERMINAL BLOCK
18
Electric wiring
OK
NO
terminal block
table clamp
.
2

Hide quick links:

Advertisement

loading