Carton Contents - Husqvarna 24B Instruction Manual

10
9
WHAT IS WHAT?
1. Throttle Lever 8.
2. Primer button 9.
3. Choke lever 10. Vacuum bag
4. Fuel cap 11. Lower vacuum tube
5. Starter rope 12. Upper vacuum tube
6. Rear handle 13. Screw for vacuum tube assembly
7. Spark plug 14. Instruction manual

CARTON CONTENTS

Check carton contents against the following
list.
S Blower
S Blower tube
S Upper vacuum tube
S Lower vacuum tube
S Screw for vacuum tube assembly
S Elbow tube
S Vacuum bag
NOTE:
It is normal for the fuel filter to rattle
in the empty fuel tank.
ASSEMBLY
WARNING:
Stop engine and be sure
the impeller blades have stopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum or
blower tubes. The rotating blades can cause
serious injury. Always disconnect the spark
plug before performing maintenance or ac-
cessing movable parts.
WARNING:
If received assembled,
repeat all steps to ensure your unit is properly
assembled and all fasteners are secure. Fol-
WHAT IS WHAT?
11
1
7
8
Blower tube
Elbow tube
ASSEMBLY
low all safety information in the manual and on
the unit.
A standard screwdriver is required for as-
D
sembly.
BLOWER TUBE ASSEMBLY
1. Align the rib on the blower tube with the
groove in the blower outlet; slide the tube
into place.
NOTE:
Knob must be loose enough to allow
blower tube to be inserted in blower outlet.
Loosen knob by turning counterclockwise.
Groove
2. Secure the tube by turning the knob clock-
wise.
3. To remove the tube, turn the knob counter-
clockwise to loosen the tube; remove the
tube.
-- 4 --
13
12
2
3
4
5
6
14
Blower
Blower
Outlet
Tube
Rib