Esata Interface - HP Compaq dc7900 USDT Technical Reference Manual

Compaq dc7900 series business desktop computers
Hide thumbs Also See for Compaq dc7900 USDT:
Table of Contents

Advertisement

5.2.2 eSATA interface

The SFF and CMT form factors provide a SATA/eSATA port (connector P64 on the system
board) that can support an external SATA (eSATA) storage device. The eSATA interface provides
higher bandwidth than USB 2.0 and Firewire (1394) interfaces.
An optional bracket/cable assembly (Figure 5-2) is required to attach an eSATA device to the
SFF or CMT system.
Figure 5-2. Optional eSATA Bracket/Cable Assembly.
The following operating parameters of the eSATA interface can be set in the ROM-based Setup
utility:
Transfer speed: 1.5 or 3 Gbps (default set to 1.5 Gbps for reliability)
Emulation mode: IDE, AHCI, or RAID (default set to AHCI)
Port availability: Available or Hidden (default set to Available)
In the IDE or AHCI modes, the system BIOS ROM controls the hard drives and Removeable
Media Boot setting applies. In the RAID mode, the RAID option ROM controls the hard drives
and the Removeable Media Boot setting does not apply.
For hot-plug functionality, the eSATA port must be set to the AHCI or RAID mode and an AHCI
driver with hot-plug support must be loaded onto the system. This driver is pre-loaded on
systems shipped with a Windows XP or Vista image. If the system is wiped clean or the Windows
OS is re-installed, the AHCI driver can be loaded by installing the OS while the eSATA
emulation mode is set to AHCI.
Technical Reference Guide
www.hp.com
Input/Output Interfaces
5-3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Compaq hp dc7900 sffCompaq hp dc7900 cmt

Table of Contents