Mounting And Wiring - GE RAK147P1 Owner's Manual And Installation Instructions

MOUNTING AND WIRING (CONT.)
2
FEED THROUGH WIRES
Feed the thermostat control wires through the
rectangular opening in the base and, using the base as a
template, mark the location of the two vertical mounting
holes.
3
MOUNT BASE TO WALL
Use the supplied anchors and screws to mount the base
to the wall by drilling two 3/16" (4.7 mm) holes at the
marked locations, and tap the nylon anchors flush to the
wall surface.
12
Installation Instructions
4
CONNECT WIRES
Connect the wires from the existing system to the
thermostat terminals according to the wiring diagrams in
Table 1 and Table 2. Push any excess wire back into the
wall and seal the hole with putty or a caulking material to
prevent drafts from affecting the ambient temperature of
the sensor. All wiring must comply with local electrical
codes and such National codes as they apply.
5
RE-INSTALL THERMOSTAT TO
BASE
To re-install the thermostat to the base, attach the tabs on
the bottom of the thermostat front to the small slots on
the base bottom and push up until they snap in place.