Figure 81 System/Network Setup Parametersunit - Emerson Liebert Challenger 3000 User Manual

Figure 81 System/Network setup parametersUnit - Page 2
SYSTEM/NETWORK SETUP (page 2 of 2)
S834
S835
S836
S837
S838
S839
S840
S841
S842
S843
S844
Monitoring Protocol—This parameter selects the monitoring protocol. Velocity V3 is the factory
default which will provide communications to the Intellislot housing. iGMNet will activate the 77/78
terminals for communications to the SiteLink(-E). Hironet is only used on HPM units.
IP Address—This parameter contains the network address of the display. This address must be
unique to every other device on the network.
Netmask—Not currently used.
Gateway—Not currently used.
MAC—The MAC address is a unique hardware identifier of the Ethernet device.
U2U Protocol—This parameter is always set to GBP.
U2U Address—This parameter is a unique identifier for each unit on the network. Display addresses
range from 33 to 64. Each display on the U2U network must have a different U2U address.
U2U Group—This parameter is used to create zones or groups within a U2U network. Once a group
number is selected the display will only see other devices with the same group number. The group
number can be changed to view other devices in different groups.
Bootloader Variables—This parameter indicates if there has been a change to the boot loader since
it was last loaded. This parameter should only be activated by an authorized service person.
PASSWORD (Actual Level 3)
Monitoring Protocol
IP Address
Netmask
Gateway
MAC
U2U Protocol
U2U Address
U2U Group
Bootloader Variables
Static RAM
Attention: any changes done on these parameters
must be followed by a 'Save+Reboot' command.
UNIT 01
192 .168.254.001
255 .255.255.000
0:000:000:000
00:00:68:1E:8E:92
Changed
OK
89
Service Menu Parameters
????
Velocity
GBP
1
1
No
No