Diskette Drive Error Messages; Serial Interface Error Messages; Table A-8. Diskette Drivee; Table A-9. Serial Interfacee - HP Compaq D315 Technical Reference Manual

Appendix A Error Messages and Codes
A.9 DISKETTE DRIVE ERROR MESSAGES (6xx-xx)
Table A–8. Diskette Drive Error Messages
Message Probable Cause
6xx-01 Exceeded maximum soft error limit
6xx-02 Exceeded maximum hard error limit
6xx-03 Previously exceeded max soft limit
6xx-04 Previously exceeded max hard limit
6xx-05 Failed to reset controller
6xx-06 Fatal error while reading
6xx-07 Fatal error while writing
6xx-08 Failed compare of R/W buffers
6xx-09 Failed to format a tract
6xx-10 Failed sector wrap test
600-xx = Diskette drive ID test
601-xx = Diskette drive format
602-xx = Diskette read test
603-xx = Diskette drive R/W compare test
604-xx = Diskette drive random seek test
605-xx = Diskette drive ID media
606-xx = Diskette drive speed test
607-xx = Diskette drive wrap test
608-xx = Diskette drive write-protect test
A.10 SERIAL INTERFACE ERROR MESSAGES (11xx-xx)
Table A–9. Serial Interface Error Messages
Message Probable Cause
1101-01 UART DLAB bit failure
1101-02 Line input or UART fault
1101-03 Address line fault
1101-04 Data line fault
1101-05 UART cntrl. signal failure
1101-06 UART THRE bit failure
1101-07 UART Data RDY bit failure
1101-08 UART TX/RX buffer failure
1101-09 Interrupt circuit failure
1101-10 COM1 set to invalid INT
1101-11 COM2 set to invalid INT
1101-12 DRVR/RCVR cntrl. signal failure
A-6 hp/Compaq Personal Computers
Table A-8.

Diskette Drive Error Messages

Message
6xx-20
6xx-21
6xx-22
6xx-23
6xx-24
6xx-25
6xx-26
6xx-27
6xx-28
--
609-xx = Diskette drive reset controller test
610-xx = Diskette drive change line test
611-xx = Pri. diskette drive port addr. conflict
612-xx = Sec. diskette drive port addr. conflict
697-00 = Diskette type error
698-00 = Drive speed not within limits
699-00 = Drive/media ID error (run Setup)
Table A-9.

Serial Interface Error Messages

Message
1101-13
1101-14
1109-01
1109-02
1109-03
1109-04
1109-05
1109-06
1150-xx
1151-xx
1152-xx
1155-xx
Changed - April 2003
Probable Cause
Failed to get drive type
Failed to get change line status
Failed to clear change line status
Failed to set drive type in ID media
Failed to read diskette media
Failed to verify diskette media
Failed to read media in speed test
Failed speed limits
Failed write-protect test
--
694-00 = Pin 34 not cut on 360-KB drive
Probable Cause
UART cntrl. signal interrupt failure
DRVR/RCVR data failure
Clock register initialization failure
Clock register rollover failure
Clock reset failure
Input line or clock failure
Address line fault
Data line fault
Comm port setup error (run Setup)
COM1 address conflict
COM2 address conflict
COM port address conflict