Self-Cleaning Instructions - GE JKP16 Use & Care Manual

it up with a damp cloth after the oven cools.
If white spots remain, remove them with a soap-
filled steel wool pad. Be sure to rinse thoroughly
with a vinegar and water mixture. These deposits are
usually a salt residue that cannot be removed by the
clean cycle.
How to Set Delay Start of Cleaning
Quick Reminder:
1. Press the AUTO SELF CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
3. Press the STOP TIME pad.
4. Press the INCREASE or DECREASE pad until
the desired Stop Time appears in the display.
Delay Start is setting the oven timer to start the clean
shows the correct time of day.
1. Follow the directions in the Before a Clean
Cycle section.
2. After t ' ~sing the door, press the
AUTO SELF
AUTO SELF CLEAN pad.
CLEAN
3. Press the INCREASE or DECREASE
pad [o enter the Clean Time.
If the oven is not clean after one clean cycle, repeat
the cycle.
If the shelves become hard to slide, wipe the shelf
supports with cooking oil.
NOTE: No functions can be programmed before the
door automatically unlocks.
4. Press the STOP TIME pad.
STOP
"SET STOP TIME" and the earliest
Stop Time you can set will appear in
the display.
The earliest Stop Time will be the Clean Time
time of day. For examPle: 1f
e
the Clean Time is 3 hours and the time of day
is 6:00, the Stop Time that appears in the display
5. Press the INCREASE pad to change
the Stop Time to a later time of day if
desired. For example: If you set the
Stop Time at 11:00, the oven will start
the clean cycle at 8:00 and end at
11 :00. The door latches automatically.
The self-clean cycle will automatically begin after
"CLEAN" is displayed and the time for the clean
cycle is set. The words "ON" and "LOCK" will
appear in the display when the door automatically
locks. It will not be possible to open the oven door
until the temperature drops below the lock
temperature and the LOCK light goes off.
NOTE:
During a delayed self-clean operation you can find
out when the oven is set to turn on by pressing and
holding the AUTO SELF CLEAN pad for 3 seconds.
A fan may automatically turn on and off to cool
internal parts. This is normal and the fan may
continue to run even after the oven is turned off.
31