Circle cutting base (Optional accessory)
Various diameter circles can be easily cut with the cordless trimmer by using the optional
circle cutting base.
I
B
Screw
I
To attach the circle cutting base, you must
first remove the standard base. This i s done
by removing the base clamp screw and
then removing the standard base from the
trimmer body. The circle cutting base is
then installed, using the same clamp screw.
Be sure to tighten the clamp screw securely.
The circle cutting base is provided with
a
"T" shaped guide rod which should be in-
stalled by inserting the long part of the rod
through the hole in the base. Pivot the
short part of the rod to position "A" and
tighten the screw.
To
cut
a
circle, first adjust the bit protru-
sion for the desired depth of cut, and then
make
a
pilot hole
a t
the center point of the
circle. Pivot the guide rod to position "B".
When using the straight bit 3, to make the
circle cut-out the thinner end of the rod
should point downward. When using the
straight bit 6, the thicker end of the rod
should point downward. Adjust the dis-
tance (L) between the rod and the bit for
the RADIUS
of
the desired circle you
intend to cut. Then tighten the screw
securely. Insert the end
of
the rod into the
pilot hole and turn on the trimmer. The
circle can now be cut by pivoting the
trimmer around the pilot hole.
Blt
Thinner end
4
f
Screw
Thinner end
Y L
15