Getting Started With Wi-Fi; Powering Wi-Fi On Or Off - HP rx3000 Series User Manual

Getting Started with Wi-Fi

Use this section to learn how to use Wi-Fi, automatically connect
to a network, manually enter new network settings, and search for
networks.

Powering Wi-Fi On or Off

Note:
the unit. If you cover up the top of the HP iPAQ after you have
turned on Wi-Fi, signal strength diminishes.
To turn on Wi-Fi from the Launch Page or traditional Today
screen, tap the Wireless icon (
button. When Wi-Fi is on, the Wireless LED (on the top-left
corner of your HP iPAQ) turns blue and the Wi-Fi button turns
amber. Once you connect to a wireless network, the Wi-Fi button
turns green.
Note:
Wi-Fi. When the blue Wireless LED is on and the arrows at the
top of the screen show connected (
connected to the wireless network.
To turn off Wi-Fi, tap the Wi-Fi button again. When Wi-Fi is off,
the Wireless LED is no longer blue and the Wi-Fi button turns
gray.
Battery Saving Tip: Turn Wi-Fi off when you are not using it.
When Wi-Fi is on, be sure one of the Wi-Fi power saving
modes is selected. Refer to
Battery"
Note:
more of the power saving modes that are available. If you cannot
connect with a particular wireless network, try turning off the
Wi-Fi Power Save modes.
User's Guide
The Wi-Fi antenna for the HP iPAQ is located in the top of
Before accessing your wireless network, you must turn on
for more information.
Some Access Points and networks do not support one or
), and then tap the Wi-Fi
), your HP iPAQ is
Chapter 10, "Managing the
Using Wi-Fi
8–2