Connecting The Power Cord - Pioneer AVH-X5500BHS Owner's Manual

Section
25 Connection

Connecting the power cord

26 pin cable (Supplied with navigation unit)
Pioneer Add-on
Insert the 26 pin cable in the direction
Navigation system
indicated in the figure.
(sold separately)
Please contact your dealer to
inquire about the connectable
navigation unit.
Yellow
Connect to the constant 12 V supply terminal.
Orange/white
Connect to lighting switch terminal.
Red
Connect to terminal controlled by ignition switch (12 V DC).
Black (chassis ground)
Connect to a clean, paint-free metal location.
Front speaker
Left
Rear speaker or
Subwoofer (4 Ω)
When using a subwoofer of 70 W (2 Ω), be sure to connect with Violet and Violet/black leads of this unit.
Do not connect anything to Green and Green/black leads.
Not used.
RGB input
This product
Antenna input
Fuse (10 A)
AUX jack (3.5 ø)
Use a mini plug cable to connect with auxiliary
device.
White Gray
Front speaker
White/black Gray/black
Right
Green Violet
Rear speaker or
Subwoofer (4 Ω)
Green/black Violet/black
Green Violet
Subwoofer (4 Ω)
× 2
Green/black Violet/black
Connection
Microphone
4 m (13 ft. 1 in.)
(Function of AVH-X5500BHS/AVH-X4500BT/AVH-X3500BHS/AVH-X2500BT)
Microphone input
(Function of AVH-X5500BHS/AVH-X4500BT/AVH-X3500BHS/AVH-X2500BT)
Wired remote input
Hard-wired remote control adapter can be connected
(sold separately).
Violet/white
Of the two lead wires connected to the back lamp, connect the one
in which the voltage changes when the gear shift is in the
REVERSE (R) position. This connection enables the unit to
sense whether the car is moving forwards or backwards.
Yellow/black
If you use an equipment with Mute function, wire this lead to
the Audio Mute lead on that equipment. If not, keep the Audio
Mute lead free of any connections.
Connection method
1. Clamp the lead.
Note:
· The position of the parking brake switch depends on the vehicle model. For details,
consult the vehicle Owner's Manual or dealer.
Light green
Used to detect the ON/OFF status of the parking
brake. This lead must be connected to the power
supply side of the parking brake switch.
Blue/white
Connect to system control terminal of the power amp or
auto-antenna relay control terminal (max. 300 mA 12 V DC).
With a 2 speaker system, do not connect anything to the speaker leads
that are not connected to speakers.
2. Clamp firmly with
needle-nosed pliers.
Parking brake
switch
Power supply side
Ground side
Note:
· Change the initial setting of this unit. The
subwoofer output of this unit is monaural.