Running The Resource Manager - HP AHA-8940 Configuration And User's Manual

Running the
Resource Manager
Chapter 2
When the VXI mainframe is turned on and the E8491A interface has been
configured using 'I_O Config', the SICL iproc utility is started. This enables
the resource manager to run when:
•
mainframe power is cycled
•
the E8491A faceplate Reset button is pressed
•
activated from the 'I_O Config' utility
The resource manager initializes and prepares the VXI system for use.
In VXI systems with multiple E8491As (mainframes), individual
mainframes can be turned off without affecting other mainframes in the
system. When a mainframe is turned on, the resource manager reconfigures
the mainframe.
Notice that the resource manager will only run if the iproc utility is started.
Again, configuring the E8491A interface using and then closing 'I_O
Config' starts iproc. You can manually start, stop, or verify the state of the
utility as shown in Figure 2-18.
Interface Installation and Configuration 33