American standard shower system kit specification sheet (2 pages)
Summary of Contents for American Standard 1660
Page 1
To ensure that your installation proceeds smoothly-- please read these instructions carefully before you begin. Recommended Tools Flat Blade Screwdriver ROUGHING-IN DIMENSIONS ALL CONNECTIONS 1/2" NPT 74mm D. (2-15/16") 1660.130 Multifunction Round Body Spray 26mm (1") 15° FINISHED WALL Installation Instructions 1660.130...
Page 2
INSTALL SUPPLY PIPING Provide a “Installation Hole” 2-1/8" - 2-3/8" DIA., (54-60mm) and 3-1/4", (83mm) deep. Note: The “Installation Hole” must be clear to allow body spray clearance. Install the ELBOW (1) on a support within the wall at the *dimension shown. Secure with two M5 SCREWS (2) (not provided).
Page 3
INSTALL BODY SPRAY Remove the PLASTER GUARD (1) if not already removed. Make sure the O-RING (2) and FLANGE GASKET (6) are installed on the BODY SPRAY (3). Thread BODY SPRAY (3) into the ELBOW (4). Tighten BODY SPRAY (3) using WRENCH (5) supplied until flush against finished wall and FLANGE GASKET (6) is compressed.