Getting Started With Switch Configuration; Recommended Minimal Configuration - HP ProCurve 5400zl Installation And Getting Started Manual

3

Getting Started With Switch Configuration

This chapter is a guide for using the console Switch Setup screen to quickly
assign an IP (Internet Protocol) address and subnet mask to the switch, set a
Manager password, and, optionally, configure other basic features.
For more information on using the switch console and the other switch
management interfaces: the web browser interface and the SNMP manage-
ment tool, ProCurve Manager, please see the Management and Configuration
Guide which is on the ProCurve Web site. See page 5-1 for details.

Recommended Minimal Configuration

In the factory default configuration, the switch has no IP (Internet Protocol)
address and subnet mask, and no passwords. In this state, it can be managed
only through a direct console connection. To manage the switch through in-
band (networked) access, you should configure the switch with an IP address
and subnet mask compatible with your network. Also, you should configure
a Manager password to control access privileges from the console and web
browser interface. Other parameters in the Switch Setup screen can be left at
their default settings or you can configure them with values you enter.
Many other features can be configured through the switch's console interface,
to optimize the switch's performance, to enhance your control of the network
traffic, and to improve network security. Once an IP address has been config-
ured on the switch, these features can be accessed more conveniently through
a remote Telnet session, through the switch's web browser interface, and from
an SNMP network management station running a network management
program, such as ProCurve Manager. For a listing of switch features available
with and without an IP address, refer to "How IP Addressing Affects Switch
Operation" in the Management and Configuration Guide which is on the
ProCurve Web site. See page 5-1 for details.
For more information on IP addressing, refer to "IP Configuration" in the
Management and Configuration Guide.
3-1