Antenna Connections; Cable Tv Connections - Sansui SLED2237 Owner's Manual

Antenna connections

If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your
antenna system. If you are using a Cable TV service, see "Cable TV connections".
Combination VHF/UHF Antenna (Single 75 ohm cable)
Antenna
Jack

Cable TV connections

This TV has an extended tuning range and can tune most cable channels without using a Cable TV
Converter box. Some cable companies offer "premium pay channels" where the signal is scrambled.
Descrambling these signals for normal viewing requires the use of a descrambler device which is
generally provided by the Cable TV company.
For subscribers to basic Cable TV service
Antenna
Jack
For subscribers to scrambled Cable TV service
If you subscribe to a Cable TV service which requires the use of a Converter/Descrambler box, connect
the incoming 75 ohm Coaxial Cable to the Converter/Descrambler box. Using another 75 ohm Coaxial
Cable, connect the output jack of the Converter/Descrambler box to the Antenna Jack on the TV. Follow the
connections shown below. Set the TV to the output channel of the Converter/Descrambler box (usually channel
3 or 4) and use the Converter/Descrambler box to select channels.
Incoming
75 ohm
Cable TV
Cable
For subscribers to unscrambled Cable TV service with scrambled premium channels
If you subscribe to a Cable TV service in which basic channels are unscrambled and premium channels require
the use of a Converter/Descrambler box, you may wish to use a signal Splitter and an A/B Switch box (available
from the Cable TV company or an electronics supply store). Follow the connections shown below. With the
switch in the "B" position, you can directly tune any nonscrambled channels on your TV. With the switch in the
"A" position, tune your TV to the output of the Converter/Descrambler box (usually channel 3 or 4) and use the
Converter/Descrambler box to tune scrambled channels.
Incoming
75 ohm
Cable TV
Cable
75 ohm
Coaxial
Cable
75 ohm
For basic Cable TV service not requiring a Converter/
Coaxial
Descrambler box, connect the 75 ohm Coaxial Cable directly
Cable
to the Antenna Jack on the back of the TV.
Converter/
Descrambler
Converter/
Descrambler
A/B Switch
Splitter
Connect the 75 ohm cable from the combination
VHF/UHF antenna to the Antenna Jack.
75 ohm Cable to TV
75 ohm Cable to TV
A
B
Antenna
Jack
Antenna
Jack
11 EN