Pride Sundancer Owner's Manual page 28

Sundancer
Hide thumbs Also See for Sundancer:
Table of Contents

Advertisement

V I I I .
FRONT-TO-BACK SEAT ADJUSTMENT
You can reposition the scooter’s seat forward or rear-
ward to one of three settings thereby adjusting the dis-
tance between the seat and the tiller.
1. Remove the seat from your scooter.
2. Remove the four bolts that fasten the seat to the seat
platform. See figure 10.
3. Align the seat platform with the desired set of holes
on the seat.
4. Replace and tighten the four bolts securely.
ARMREST WIDTH ADJUSTMENT
The scooter armrest width can be adjusted inward or out-
ward.
1. Loosen the armrest adjustment knobs at the back of
the seat frame. See figure 10.
2. Slide the armrests in or out to the desired width.
3. Tighten the armrest adjustment knobs as required.
The armrests can also be lifted upward to aid in getting
onto and off of your scooter.
SEAT HEIGHT ADJUSTMENT (POWER SEAT POST)
Your scooter may be equipped with a power seat. The power seat actuator is designed to raise or lower the seat
with minimal effort on the part of the operator.
WARNING! The power seat is intended for operation only while your scooter is stationary
and on a level surface. Its purpose is to aid you in reaching objects.
Failure to comply with the following instructions, warnings, and safety rules for power
seat use could result in serious personal injur y and damage to your scooter.
Operating your power seat:
1. Release the throttle control lever and allow the scooter to come to a complete stop.
2. Ensure that your scooter is level and stationary.
3. Set the speed adjustment dial to the slowest setting.
4. Toggle the power seat switch located on the tiller console to the “on” position.
5. To raise the power seat, operate your throttle control lever in the forward direction.
6. Release the throttle control lever when you have attained your desired height.
7. To lower the power seat, operate your throttle control lever in the reverse direction.
8. Ensure that your seat is in the lowest position and that you have fully released the throttle control lever.
9. Toggle “off” the power seat switch before you attempt to drive your scooter again.
NOTE: Frequent use of the power seat will more rapidly drain the charge of the batteries.
28
C O M F O R T
www.pridemobility.com
A D J U S T M E N T S
ARMREST ADJUSTMENT KNOBS
BOLTS
Figure 10. Seat Adjustments
SEAT LOCK LEVER
Sundancer

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents