TP-Link TL-WR940N User Manual page 105

Note:
If the above configuration takes effect, to configure to the router by typing
http://192.168.0.1:88
field of the Web browser.
3) Log in to the router, click the "Forwarding" menu on the left of your browser, and click
the "Virtual Servers" submenu. On the "Virtual Servers" page, click Add New..., then
on the "Add or Modify a Virtual Server" page, enter "80" into the blank next to the
"Service Port", and your IP address next to the "IP Address", assuming 192.168.0.188
for an example, remember to Enable and Save.
5. The wireless stations cannot connect to the router.
1) Make sure the "Wireless Router Radio" is enabled.
2) Make sure that the wireless stations' SSID accord with the router's SSID.
3) Make sure the wireless stations have right KEY for encryption when the router is
encrypted.
4) If the wireless connection is ready, but you can't access the router, check the IP Address
of your wireless stations.
TL-WR940N/TL-WR941ND
(the router's LAN IP address: Web Management Port) in the address
Figure A-9 Virtual Servers
Figure A-10 Add or Modify a Virtual server Entry
300Mbps Wireless N Router
-96-