Installing the Cisco Unified IP Phone
Installing the Cisco Unified IP Phone
Procedure
1. Attach the footstand to the
back of the phone. See
Figure 3-1
and
Figure
2. Connect the handset to the
Handset port.
3. Connect the power supply to
the Cisco DC Adapter port.
4. Connect a Category 3 or 5
straight-through Ethernet cable
from the switch to the 10/100
SW port.
5. (Cisco Unified IP Phone
7911G only) Connect a
Category 3 or 5 straight-through
Ethernet cable from another
network device, such as a
desktop computer, to the 10/100
PC port.
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager 5.1
3-10
You must connect the Cisco Unified IP Phone to the network and to a power
source before using it. See
the procedures that follow.
To install a Cisco Unified IP Phone, perform the following steps:
Notes
—
3-2.
—
Optional. When connecting phones
powered by an external power supply,
you must connect the power supply to
the phone before connecting the
Ethernet cable to the phone.
When disconnecting the phone, you
must disconnect the Ethernet cable
before disconnecting the power
supply.
Each Cisco Unified IP Phone ships
with one Ethernet cable in the box.
Optional. You can connect another
network device later if you do not
connect one now.
Chapter 3
Figure 3-1
and
Figure 3-3
Setting Up the Cisco Unified IP Phone
for a graphical overview of
Reference
—
—
See the
"Providing Power to
the Cisco Unified IP Phone
7906G and 7911G" section
on page
2-4.
See the
"Network and
Access Ports" section on
page 3-5
for guidelines.
See the
"Network and
Access Ports" section on
page 3-5
for guidelines.
OL-11515-01