Cisco 7906G Administration Manual page 131

Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Table 4-14 SIP General Configuration Menu Options
Option
Preferred CODEC
Out of Band DTMF
Register with Proxy
Register Expires
Phone Label
Enable VAD
VOIP Control Port
Start Media Port
End Media Port
Backup Proxy
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager 5.1
OL-11515-01
Description
Displays the CODEC to use when a call
is initiated.
Displays the configuration of the
out-of-band signaling (for tone detection
on the IP side of a gateway). The
Cisco Unified IP Phone (SIP) supports
out-of-band signaling using the AVT
tone method. Valid values are none, avt,
and avt_always.
Displays if the phone must register with
a proxy server during initialization.
Displays the amount of time, in seconds,
after which a registration request expires.
Displays the text that is displayed on the
top right status line of the LCD on the
phone. This text is for end-user display
only and has no effect on caller
identification or messaging.
Displays if voice activation detection
(VAD) is enabled.
Displays the UDP ports used for SIP
messages.
Displays the start Real-Time Transport
Protocol (RTP) range for media.
Displays the end Real-Time Transport
Protocol (RTP) range for media.
Displays the IP address of the backup
proxy server or gateway.
Device Configuration Menu
To Change
Display only—cannot configure.
Display only—cannot configure.
Display only—cannot configure.
Use Cisco Unified CallManager
Administration > Device > Device
Settings > SIP Profile.
Display only—cannot configure.
Use Cisco Unified CallManager
Administration > Device > Device
Settings > SIP Profile.
Use Cisco Unified CallManager
Administration > Device > Device
Settings > SIP Profile.
Use Cisco Unified CallManager
Administration > Device > Device
Settings > SIP Profile.
Use Cisco Unified CallManager
Administration > Device > Device
Settings > SIP Profile.
Display only—cannot configure.
4-27