Cisco 6000 Series Site Planning Manual page 45

Chapter 4 Site Planning Considerations
Table 4-1
RP Card Port
Console port 0
Console port 1
Console port 2
Ethernet management
port 0
Ethernet management
port 1
Control plane expansion
Ethernet port 0
Control plane expansion
Ethernet port 1
Six interface shelf
Ethernet ports
Sync port for external
BITS clock
Sync port 0 for
BITS/J.211 time
reference input
Sync port 1 for
BITS/J.211 time
reference input
GPS Time Transfer
Interface (TTI) port
Cisco Time Expansion
port
IEEE 1588 time
synchronization port
USB 2.0 port for external
storage
Alarm port
OL-29236-02
RP Card Cables
Required Cable Type
RJ-45 port for straight-through EIA/TIA-232 cable.
RJ-45 port for straight-through EIA/TIA-232 cable.
RJ-45 port for straight-through EIA/TIA-232 cable.
RJ-45 port for shielded twisted-pair (STP) cable Cat5e or better.
Port for SFP+ optical module capable of up to 10-Gbps operation.
For example: copper SFP-GE-T, 1GE SFP-GE-L, SFP-GE-S,
10G-SFP-SR and 10G-SFP-LR
Port for SFP+ optical module capable of up to 10-Gbps operation.
Port for SFP+ optical module capable of up to 10-Gbps operation.
Port for SFP+ optical module capable of up to 10-Gbps operation.
Cat5 or better unshielded twisted-pair (UTP) cable.
RJ-45 for STP cable Cat5 or better.
RJ-45 for STP cable Cat5 or better.
RJ-45 port for STP cable Cat5 or better, RF 1.0/2.3 coax connectors.
RJ-45 port for STP cable Cat5 or better.
RJ-45 port for STP cable Cat5 or better.
—
Shielded 15-pin D-SUB cable with male connector.
Cisco Network Convergence System 6000 Series Routers Site Planning Guide
Cable Management
4-5