Download Print this page

HP Mini 700 Maintenance And Service Manual: Heat Sink Assembly

Hewlett-packard netbook maintenance and service guide.
Hide thumbs

Advertisement

9.
Grasp the system board at its midpoint (1) and lift the right side (2) up. Then remove the system
board (3) from the base enclosure.
Reverse the procedure to install the system board.

Heat sink assembly

NOTE:
The heat sink assembly spare part kit includes replacement thermal material.
Description
Heat sink assembly
Before removing the heat sink assembly, follow these steps:
1.
Shut down the device. If you are unsure whether the device is off or in Hibernation, turn the device
on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the device.
3.
Disconnect the power from the device by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the device.
4.
Remove the battery (see
5.
Remove the following components:
a.
Keyboard (see
b.
Hard drive or solid-state drive (see
c.
Top cover (see
d.
WLAN module (see
Remove the heat sink assembly:
1.
Remove the two Phillips PM1.6×2.5 screws (1) that secure the heat sink assembly to the system
board.
Battery on page
37).
Keyboard on page
40)
Mass storage devices on page
Top cover on page
45)
WLAN module on page
42)
48)
Component replacement procedures
Spare part number
515099-001
57

Advertisement

   Related Manuals for HP Mini 700

Comments to this Manuals

Symbols: 0
Latest comments: