Rtc Battery - HP G62 Maintenance And Service Manual

6. Remove the module (2) by pulling it away from the slot at an angle.
NOTE:
memory module slot.
Reverse this procedure to install a memory module.

RTC battery

Description
RTC battery
Before removing the RTC battery:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn on
the computer, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first disconnecting the power cord from the AC
outlet and then disconnecting the AC adapter from the computer.
4. Remove the battery (see
Remove the RTC battery:
1. Unplug the RTC battery from the system board (1).
2. Use a sharp, non-conductive, tool to release the RTC battery from the adhesive material that
secures the RTC battery to the system board..
Memory modules are designed with a notch (3) to prevent incorrect insertion into the
Battery on page 41).
Component replacement procedures
Spare part number
606015-001
51