Technical Information; Installation Considerations - Hans Grohe 06630XX0 Installation Instructions Manual

3-hole roman tub rough 3-hole roman tub trim kits
Table of Contents

Advertisement

3-Hole Roman Tub Rough
06607000

Technical Information

Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Hole size in mounting surface
valves
spout
spout retaining pin
Max. mounting surface depth
Max flow rate
*Please know and follow all applicable local plumbing codes when setting the temperature on the water heater.

Installation Considerations

For best results, this unit should be installed by a licensed, professional plumber.
Large differences in pressure between the hot and cold supplies should be balanced.
The included connecting tubes are type "K" copper tubing. If an installation different from the one
shown here is desired, the plumber may provide his own copper tubing.
To insure proper fit of the trim, this valve must be installed after the mounting surface is finished and
made watertight.
This valve requires ½" hot and cold supply lines (not included)
The hot and cold water supplies should be flushed thoroughly before installation of this rough valve.
Damage to the cartridges caused by debris is not covered by the warranty.

45-80 psi
145 psi
10° - 140° F*
165°F*
1¼"
1⅜"
³⁄₁₆"
1⁹⁄₁₆"
10 gpm

Advertisement

Table of Contents
loading

Table of Contents