Table of Contents
Advertisement
System Operation (cont'd)
NOTE: Bypassed zones are NOT protected when the system is armed.
After the bypass command has been accepted, the keypad sounds one
long beep, and the following is displayed:
LCD Keypad:
BYPASSED:
FRONT DOOR
To Unbypass a Zone
Pressing the BYPASS button returns a bypassed zone to normal
operation. To unbypass a zone(s), repeat the bypass function as
follows:
BYPASS
After unbypassing, the zone display shows the state of the zones.
†
If the Quick Bypass feature has been enabled by the installer, do not
enter the User Code when unbypassing zones.
Disarming the System
When you disarm the system, you disarm only the burglar portion of
your system; any smoke or heat detectors and panic keys will remain
armed. You must enter through a designated entry door and disarm
the system within the time allowed. You can have different amounts
of time for different entry points. See your system reference sheet for
the times established for your system.
To disarm your system:
Enter your User Code.
– 14 –
Fixed-Word Keypad:
BYPASS
ZN1
zone number displayed
followed by your User Code
†
and Zone No. (1-8)
Advertisement
Table of Contents
