HP 600 Series User Manual page 90

|
When you enter the IP address, you can also choose to use SLIP (Serial Line
Internet Protocol) if your network uses this protocol. PPP (Point-to-Point
Protocol) is the default protocol for this option, but SLIP is supported as
well. If you have a SLIP account, select the Use SLIP check box during the
IP setup portion of the HP Jornada dialup configuration process.
If you choose to configure an e-mail service, HP dialup will prompt you to
enter the following information:
UserID and password— The user name (UserID) and password you use to
access your e-mail account may be the same as the user name and password
you use to log on to your network. However, sometimes another name and
password are used for this service.
Service types—Your network may use POP3 or IMAP4 protocol for receiving
mail. In addition, some networks use SMTP for sending messages. Refer to
your network administrator to find out if this applies to your configuration.
Settings—You can choose a variety of E-mail service settings. If your mail
server supports MIME formatting (Multipurpose Internet Mail Extensions)
encoding (POP3 servers only), you can select an option to allow binary files to
be sent as attachments to e-mail messages. You can also set e-mail services to:
• Disconnect after actions are performed.
•
Check for new mail at specified intervals.
• Display a message or sound an alarm when new mail arrives.
• Only display messages from a specified number of recent days.
• Download only message headers. (You can review headers and decide
whether to download message bodies the next time you connect.)
• Download full copies of all messages. (You can review messages and
decide whether to download attachments the next time you connect.)