Removing Bezel Blanks; Replacing The Front Bezel - HP 6000 Hardware Reference Manual

Removing Bezel Blanks

On some models, there are bezel blanks covering the 3.5-inch and 5.25-inch external drive bays that
need to be removed before installing a drive. To remove a bezel blank:
1. Remove the access panel and front bezel.
2. To remove a bezel blank, push the two retaining tabs that hold the bezel blank in place towards
the outer right edge of the bezel (1) and slide the bezel blank back and to the right to remove it (2).
Figure 2-5

Replacing the Front Bezel

Insert the three hooks on the left side of the bezel into the rectangular holes on the chassis (1) then
rotate the right side of the bezel onto the chassis (2) and snap it into place.
Figure 2-6
12 Chapter 2 Hardware Upgrades
Removing a Bezel Blank
Replacing the Front Bezel
ENWW