Program Loading The Ice Terminal - Hypercom ICE 5700 Hardware And Installation Operators Manual

Program Loading the ICE Terminal

A program load is required when no software is currently in the terminal. Depending on the software
application, an average program load takes approximately 40 minutes to complete. The initialization
process loads the merchant-specific information in a terminal.
MAC software is required when the ICE 5700 supports debit processing. Please refer to the ICE 5000
PIN Pad Loader Operators Manual for further details.
Step-by-Step
To load a program into the ICE terminal:
Step Action
The Idle prompt appears.
1 Touch 2 on the terminal display.
2 Touch Enter to continue. The following screens appear.
The terminal checks the dial line.
The terminal dials the host.
The terminal waits for the host to answer.
The terminal connects to the host.
The terminal sends request information to the host.
The program load begins.
940310-001, rev. A Hypercom Corporation
Setup Procedures
Terminal response
PLEASE INITIALIZE
OR CALL HELP - PE
0: RESTART
1: MERCHANT PROGRAMMING
2: PROGRAM LOAD
3: CLEAR PAGE MEMORY
4: MAINTENANCE FUNCTIONS
5: FAST LOAD
PROGRAM LOAD
CORRECT? YES OR NO
CANCEL CLEAR ENTER
PROCESSING YOUR
REQUEST
Please wait and
watch for message
CHECKING LINE
WAITING FOR DIAL TONE
DIALING NOW
WAITING FOR ANSWER
TRAINING MODEM
PROCESSING NOW
LOADING MEM XX XXXX
3-3