Electrolux CXH09HL1W User Manual page 5

Explanation of buttons
No. Button
17 ON/OFF
18 MODE
19 FAN
20 UP ^
21 DOWN v
22 CLOCK
23 LIGHT
24 TURBO
25 X-FAN
26 ION-FILTER
Explanation
Press the button to switch on the unit. Press the button again to
switch off the unit.
Press the button to set the operation mode: AUTO, COOL, DRY,
FAN and HEAT. Default setting: AUTO.
In the AUTO mode, the temperature is not shown. In HEAT mode,
the initial value is 28 °C (82 °F). In other modes, the initial value is 25
°C (77 °F).
Press the button to set the fan speed: AUTO, LOW, MEDIUM LOW,
MEDIUM, MEDIUM HIGH and HIGH. Default setting: AUTO. In the
DRY mode, only LOW can be set.
Press the button to increase the temperature. Keep the button
pressed for two seconds to accelerate the process. Release the
button to set the temperature and send the order that the °C/°F
signal will be displayed constantly.
Temperature range: 16-30 °C (61-86 °F).
In AUTO mode, the temperature cannot be set. If you press the UP
or DOWN button, a beep will sound.
Press the button to decrease the temperature. Keep the button
pressed for two seconds to accelerate the process. Release the
button to set the temperature and send the order that the °C/°F
signal will be displayed constantly.
Temperature range: 16-30 °C (61-86 °F).
In AUTO mode, the temperature cannot be set, but the order can be
sent by pressing the button.
Press the button to set the clock. If the clock symbol blinks, press
the UP or DOWN button to set the time. Keep the button pressed
for two seconds to accelerate the process. Press the CLOCK button
again to set the clock. The clock symbol stops blinking.
After battery replacement, "12:00 PM" will be shown. If the clock
symbol is visible, the actual time will be shown. If the clock symbol is
not visible, the timer will be shown.
Press the button to switch the display of the indoor unit on or off.
Default setting: OFF.
In COOL or HEAT mode, press the button to enable or disable the
turbo function. If the turbo function is enabled, the turbo symbol will
be shown. Default setting: OFF.
If the turbo function is enabled, the unit will operate at turbo speed
to cool or heat rapidly so that the ambient temperature approaches
the set temperature as soon as possible.
If the operation mode or the fan speed is changed, the turbo symbol
will not be shown.
In COOL or DRY mode, press the button to enable or disable the
X-FAN function. If the X-FAN function is enabled, the X-FAN symbol
will be shown. Default setting: OFF.
If the X-FAN function is enabled, the indoor fan will continue opera-
tion at low speed for 10 minutes after switching off the unit. This
function prevents the possible condensation on cold parts of the
indoor unit. Press the X-FAN button to switch off the unit during the
process.
If the X-FAN function is disabled, the unit will be switched off im-
mediately.
In AUTO, FAN or HEAT mode, X-FAN is not available.
Press the button to enable or disable the operation of the health
fi lter.
www.electroluxaircomfort.com 5